1．Features: 

① Being able to be directly welded onto a PCB;

② Pin-grid of 2.54mm, meeting the requirements of computerized board arrangement;

③ Completely encapsulated, providing strong mechanical and environmental endurance, strong dielectric strength, and an elegant outline;

④ Lightweight, small in size, high in accuracy, wide in sampling range, and flexible in applications.

2．Ambient Conditions:

① Ambient temperature: -55℃～+85℃;

② Relative humidity: ≤90% at 40℃;

③ Atmospheric pressure: 860～1060mbar(about 650～800mmHg).

3．Operating Frequency Range: 20Hz~1kHz

4．Insulation Thermal Class：Class F (155℃)

5．Safety Features:

① Dielectric resistance: >1000MΩ in normal condition;

② Insulation withstand voltages: 6000V 50Hz/1min;

③ Fire retardancy: In conformity with UL94-V0.

6．Outline Drawing, Installation Dimension and Coil Diagram: ( tolerance ± 0.5mm )

7．Typical Application and Technical Parameters:

①The parameters are listed in Table 1 while the sampling voltage is obtained directly by using a resistor (as shown in Fig.1 below).

②The parameters are listed in Table 2 while the sampling voltage is obtained by using an IC (as shown in Fig.2 below). 

Table 1：

Table 2：

 8．Attention:

① Connect the primary winding of the current transformer in series with the measured current loop, and operate the secondary winding in near short-circuit mode.

② Do not allow the secondary winding of the current transformer to be open-circuited and do not install any fuse in the secondary circuit.