1．Features:

① The busbar is built-in, the flexible wire is led out, and the printed circuit board is directly welded and installed;

② Small size, high precision, beautiful appearance;

③ Fully enclosed, good mechanical and environmental resistance, strong voltage isolation capability.

2．Ambient conditions:                    

① Ambient temperature: -55℃～+85℃;

② Relative humidity: ≤90% at 40℃;

③ Atmospheric pressure: 860～1060mbar(about 650～800mmHg).

3．Operating Frequency Range: 20Hz~20kHz

4．Insulation Thermal Class：Class B (130°C)

5．Safety Features:

① Insulation resistance: >1000MΩ in normal condition;

② Insulation withstand voltages: 6000V 50Hz/1min;

③ Fire retardancy: In conformity with UL94-V0.

6. Outline Drawing, Installation Dimension and Coil Diagram : ( tolerance ± 0.5mm ) 

① Outline drawing and installation dimensions are shown in Figure 1:

② The coil diagram is shown in Figure 2: 

                      Fig 1

                   Fig 2

7. Typical Application and Performance Parameters:

① When the sampling voltage is directly obtained by the resistance method ( as shown in Figure 3 ) , the performance parameters are shown in Table 1 ;

② When using the IC method to obtain the sampling voltage ( as shown in Figure 4 ) , the performance parameters are shown in Table 2.

Table 1 :

Table 2 :

8．Attention:

① Connect the primary winding of the current transformer in series with the measured current loop, and operate the secondary winding in near short-circuit mode.

② Do not allow the secondary winding of the current transformer to be open-circuited and do not install any fuse in the secondary circuit.