1．Features:

① Vertical core-through, printed circuit board directly soldered and installed;

②Small size, high precision, beautiful appearance;

③ Fully enclosed, good mechanical and environmental resistance, strong voltage isolation capability.

2．Ambient Conditions:

① Ambient temperature: -55℃～+85℃;

② Relative humidity: ≤90% at 40℃;

③ Atmospheric pressure: 860～1060mbar(about 650～800mmHg).

3．Operating Frequency Range: 20Hz~1kHz

4．Insulation Thermal Class: Class B (130°C)

5．Safety Features:

① Dielectric resistance: >1000MΩ in normal condition;

② Insulation withstand voltages: 6KV 50Hz/1min;

③ Fire retardancy: In conformity with UL94-V0.

6. Outline Drawing, Installation Dimension and Coil Diagram: ( tolerance ± 0.5mm)

7. Typical Applications and Performance Parameters:

① When the sampling voltage is directly obtained by the resistance method ( as shown in Figure 3 on the upper right ), the performance parameters are shown in Table 1;

② When using the IC method to obtain the sampling voltage ( as shown in Figure 4 on the upper right ), the performance parameters are shown in Table 2 ;

Table 1 :

Table 2 :

8. Attention:

① Connect the primary winding of the current transformer in series with the measured current loop, and operate the secondary winding in near short-circuit mode.

② Do not allow the secondary winding of the current transformer to be open-circuited and do not install any fuse in the secondary circuit.