TA8595 Series Zero Sequence Current Transformer

LI138V2 /2016

1．Features:

① It can measure the zero-sequence current in the system whose main circuit current is below 500A;

② 
Fully enclosed, good mechanical and environmental resistance, strong voltage isolation capability, safe and reliable;

③ Soft line output, easy to use and flexible.

2．Ambient Conditions:

① Ambient temperature: -55℃～+85℃;

② Relative humidity: ≤90% at 40℃;

③ Atmospheric pressure: 860～1060mbar(about 650～800mmHg).

3．Operating Frequency Range: 20Hz~1kHz

4．Insulation Thermal Class：Class B (130°C)

5．Safety Features:

① Insulation resistance: >1000MΩ in normal condition;

②Insulation withstand voltages: 6KV 50Hz/1min;

③ Fire retardancy: In conformity with UL94-V0.

6. Outline Drawing, Installation Dimension and Coil Diagram:( tolerance ± 1mm )

① Outline drawing and installation dimensions are shown in Figure 1 :

② The coil diagram is shown in Figure 2 :

7. Typical application and performance parameters:

See the table below for the application performance parameters shown in Figure 3.

● Notes:

a. In practical applications, the sampling resistance should be less than or equal to the rated value given in the above table, which will improve the nonlinearity and phase shift;

b. If the conversion ratio required by the user is different from the above, it can be customized according to the user's requirements.

8. Attention:

① The primary of the current transformer should be connected in series with the circuit being measured, and the secondary should work close to a short circuit condition.

② The secondary circuit of the current transformer should not be open-circuited. Therefore, please do not install fuses.